|
find a spot for a room, in this case a garage |
|
frame in a room and add a door |
|
make sure to be secured by tieing into an existing wall |
|
Add caption |
|
board the walls with your preferred material |
|
paint/seal the walls with flat white paint, make sure to triple coat |
|
make a frame 4x8 to saw the holes in the root chamber lids |
|
you need to use a 4 3/4' hole saw for the basket holes in the lids |
|
i prefer using a drill with cord to saw wood with, more power |
|
usually each lid will have 15 plant sites and 1 exhaust hole this case its 8 |
|
i seal the bottoms of the tables, OSB can gas off if it gets too hot |
|
heres 100 babies, il only pic the best 32 for the mft room (med man method) |
|
screw 2 x 6 frames to the bottom painted sheets |
|
add a joint support where both 4x8 shhets meet (if longer then 8 foot mfts) |
|
il be using a 3 fan swamp chiller and 12 600w adjustawings |
|
i always use 3 screws for the table legs |
|
table legs are all attached upside down for ease |
|
flip tables and stand the up |
|
make sure the bubble tops out for every slope |
|
100 gallon growtek res |
|
remember to saw drain holes in the root chamber |
|
line the bed with vapor barrier |
|
top tables with pre sawed lids. make sure all dust is cleaned |
|
grab some bathroom caulk, clear looks cleanest |
|
i love using craft paper cutters to cut all the vapor barrier and reflctive poly |
|
caulk a solid beed around each hole |
|
use 2 fingers and a circular motion to spread the cualk from the hole out 3-5 inches |
|
once all holes are treated, over lay with poly and forcefully press poly to cualk |
|
make sure theres no air between poly and cualk |
|
a finished hole |
|
cut out any poly covering the holes after 24 hours |
|
flip lids and line with reflective material |
|
cut a double cross with a razor blade/box cutter only cut 4 inches |
|
get a drill and a 1/4 inch drill bit |
|
screw 2 opposing holes in each basket |
|
force each basket in their holes, the poly should be smaller then the basket |
|
notice the tension in the poly, |
|
half done plumbing |
|
make sure all fittings are snug |
|
secure the pipe with cable staples, or any means you have that will work |
|
this is a hole puncher tool and the 1/4 inch pipe adapters
connect the half inch female to the magdrive pump,
|
connect the half inch female to the magdrive pump, then a ball/flow valve, then a T connector, run the pipe to elbows in between both rows, then run the yube the lenght of the table.
once secured, poke drip holes, add the 1/4 inch adapters, then drip tube to the 1/4 inch holes predrilled in the baskests
make sure to leave at least an inch when cutting the double cross for the basket holes, to make sure the poly stretches and covers any exposed wood
make sure the water is draining properly. an x is cut in the vapor barrier then spread with a fist to make it a bit more circular
here is my latest build of mfts. they are 16 feet long, and will hold a total of 32 plants (16 for each length, 4 plants per 4x4 area.
|
you want to run 10 ml/liter of hyox for 24 hours to clean and disinfect the res, plumbing and root chambers d caption |
|
day 1 planting |
|
day 7 bubble haze |
|
day 7 over all |
|
day 7 root mass |
|
day 7 chocolate og |
|
day 7 roots |
|
day 7 |
|
day 7 - ladybug bubba |
|
day 7 - med mans og |
|
day 7 med mans head band #2 |
|
day 7 - maple ridge master kush |
|
day 7- pure afghani |
|
rks #1 day 7 |
|
rks #2 and #3 (left) day 7 |
|
rks #4 |
|
day 7 rock star cheese aka silver rocks star skunk |
|
day 7 - the rock star kush |
|
day 7 - silver skunk bx1 |
|
ultra violet day 7 |
|
day 13 root shots |
|
day 13 |
|
day 13 |
|
day 13 |
|
day 13 |
|
day 13 ultra violet |
|
day 13 ultra violet |
|
day 13 ultra violet |
|
day 13 ultra violet |
|
day 14 left side |
|
day 14 right side |
|
day 7 for one of the mfbs (rock star cheese) |
|
day 14 - rks #4 |
|
day 14 bubble haze |
|
day 14 choclate og |
|
day 14 - rks #1 |
|
day 14 - pure afghani |
|
day 14 - chocolate og #2 |
|
day 14 rks #2 left rks #3 right |
|
day 14 silver skunk bx1 left rock star cheese #3 right |
|
day 14 |
|
day 14 |
|
day 14 - maple ridge master kush |
|
day 14 - lady bug bubba |
|
day 14 - west coast sour diesel |
|
day 14 - rock star kush |
|
day 14 - super sour diesel |
|
day 14 more lady bug bubba |
|
day 14 more lady bug bubba |
|
day 14 (just planted) the fern |
|
day 14 - med-mans og |
|
day 14 - lady bug bubba |
|
day 7 for mfb - purple rock star kush |
|
day 7 for mfbs - super sour diesel #1 |
|
day 14 med-mans og |
|
day 14 |
|
day 14 |
|
day 14 |
|
day 7 for mfb - super sour diesel |